GE Fanuc智能设备
PLC 编程软件快速入门
All rights reserved. No part of this publication may be reproduced in any form or by any electronic or mechanical means, including photocopying and recording, without permission in writing from GE Fanuc Automation Americas, Inc..
Disclaimer of Warranties and Liability
The information contained in this manual is believed to be accurate and reliable. However, GE Fanuc Automation Americas, Inc. assumes no responsibilities for any errors, omissions or inaccuracies whatsoever. Without limiting the foregoing, GE Fanuc Automation Americas, Inc. disclaims any and all warranties, expressed or implied, including the warranty of merchantability and fitness for a particular purpose, with respect to the information contained in this manual and the equipment or software described herein. The entire risk as to the quality and performance of such information, equipment and software, i
s upon the buyer or user. GE Fanuc Automation Americas, Inc. shall not be liable for any damages, including special or consequential damages, arising out of the use of such information, equipment and software, even if GE Fanuc Automation Americas, Inc. has been advised in advance of the possibility of such damages. The use of the information contained in the manual and the software described herein is subject to GE Fanuc Automation Americas, Inc. standard license agreement, which must be executed by the buyer or user before the use of such information, equipment or software.
Notice
GE Fanuc Automation Americas, Inc. reserves the right to make improvements to the products described in this publication at any time and without notice.
©2003 GE Fanuc Automation Americas, Inc. All rights reserved. CIMPLICITY is a registered trademark of GE Fanuc Automation. Any other trademarks referenced herein are used solely for purposes of identifying compatibility with the products of GE Fanuc Automation Americas, Inc.
1.介绍 1
系统需求 3
安装 4
产品注册 5
技术支持7
2.CIMPLICITY Machine Edition简介9
快速入门10
工程12
工具栏14
变量16
选项19
Machine Edition 帮助20 在线帮助20
信息浏览帮助20
3.GE Fanuc PLC 目标对象23
增加、配置和转换对象24 增加对象24
配置对象25
转换对象26
4.配置通讯28
配置以太网或串口通讯28
入门编程软件哪个好
配置 PACSystems 通讯28
在非 PACSystems PLC 中的通讯配置30 编程器与PLC 的交互操作33 检验对象33
在线/离线33
上载/下载35
运行/停止PLC 36
故障表37
参考变量察看表38
报告40
CIMPLICITY Logic Developer-PLC Version 4.00 Ⅰ
5.硬件组态(HWC43
PACSystems TM RX7i 43 PACSystems TM RX7i 硬件组态44 冗余(仅对系列 90TM -70 和PACSystems TM RX7i50 冗余系统组态52 系列90TM -30 :DSM314运动模块55 系列90TM -70 远程 I/O 扫描器57 VersaMax 远程I/O 59